24mm (for electrode and separator discs of CR24xx series)
Note:By using 24mm and 15mm die,can prepare 15mm ID x 24mm OD O-ring as reference ring for three-electrode split test cell ( The special die can be ordered in the options bar at extra cost)
Product Dimensions
With handle: 140mm(L) x 220mm(W) x 338mm(H)
Without handle: 140mm(L) x 220mm(W) x 150mm(H)
Warranty
One-year limited manufacturer warranty with lifetime support
Rusted and damaged parts due to improper storage condition or maintenance are not covered by warranty
Application Notes
If you are going to make CR2016, CR2025 or/and CR2032 coin cell batteries, you will need at least three cutting dies:
15mm (for negative side case, which is 16.5mm in diameter)
19mm (for positive side case, which is 20mm in diameter)
20 mm (for the separator to fully separate the electrodes in both negative and positive cases)
In order to cut thin separator, please cut it together with an A4 paper for a better result
In order to cut Li-Foil and other thin film, please contact.
For CR2450 coin cells, a 20mm cutting die can be used for cutting electrode discs and the 24mm cutting die can be used for cutting either electrode discs or separator discs
Separator discs must be large enough to fully separate the positive and negative electrodes to avoid short-circuit inside the coin cells
Warning: You must pay great attention to die change from one size to another. Misalignment will result in die damage. Please read the operation manual carefully when changing die. MTI is not responsible for the damage caused by misoperation. Strongly suggest buying several cutters with pre-installed die sets.
Compliance
CE Certified. NRTL certification is available upon request at the extra cost
Net weight
15 kg (33 lbs)
Shipping Weight
30 lbs
Shipping Dimensions
19" x 8" x 12"
Instruction and Video
General video How to cut O-ring video How to make coin cell Die Alignment Instructions