| Max. Pressure |
• 24 Metric Ton- • Pressure gauge is built in
|
Gauge Pressure
Value to Force
Conversion
|
Gauge Displayed Pressure Value (Mpa)
| 5
| 10 | 15 | 20 | 25 | 30 | 35 | 40 | 45 | | Actual Force Applied to the Hydraulic Cylinder (Ton) | 3 | 6 | 9 | 11 | 14 | 17 | 19 | 22 | 24 |
- º Displayed pressure value to actual applied force conversion: 1 MPa = ~ 0.55 Ton
- º The actual force applied to the vessel cylinder (Ton) equal to the force applied to your working piece
- º For calculating the actual pressure (Mpa) applied to your working piece, please follow the equations
below: - º P = T x g x 10/ (πr^2)
- º P: pressure (Mpa) applied to your working piece
- º T: force (metric ton) applied to the pressure vessel cylinder
- º g: standard gravity. g ≈ 9.8 m/s2
- º π: ~3.14
- º r: radius (cm) of the pressure vessel (1.5 cm)
- º *1000 Kg = 1 Metric Ton; 1 Mpa = 10 Kg/cm2
|
| Hydraulic Machine |
• 24T Max.- • The manual hydraulic pump is separated from the cylinder for safe operation
|
Operation
Temperature | 10 - 40°C |
Bottom Cylinder
Traveling Distance | 20 mm maximum. The bottom cylinder (piston) is shown in the illustration in dimension section. |
Overall Dimension
| Press: 220 L x 220 D x 269 H(min), mm
Rocker base: 110 L x 330 D x 200 H(min), mm |
Pressing Die
(Optional) |
Pressing dies with various diameters are available upon request at extra cost
|
| Optional |
Electric pump with programmable pressure control is available upon request
 
|
| Net Weight | 100 kg |
Shipping Weight
& Dimension | 160 lbs; 48"x40"x40" |
| Compliance | CE Certified |
| Warranty |
• The pressing machine was quality inspected in the USA, lifetime support is provided- • One year limited standard warranty (Extended warranty is available up to 5 years at extra cost).
|
Operation Video
and Instructions |
 
|
| Application Notes |
• The pressing die cannot be used for pressing powder with particle size < 30 microns. Small particles may slip
into the gap between pushing rod and steel sleeve and cause damages to the sleeve during the compression.
Ball mill and sieve the powder and apply only the 32~75 microns powder to the pressing die to avoid the
damages. Please consider using the 3'' Dia. Sieve Set No.200&450 Mesh to separate the 32~75 microns
particles from the powder clumps. Please clean the mold via ethanol after the completion of each experiment.
- • Do not raise the bottom cylinder (piston) more than its maximum traveling distance. (25 mm)
 
- • Warning: Customers must always wear protective goggles during operation !!!
- • Operate the presser inside the glove box is not recommended.
|
