Ni based super-alloy tube vessel (50 mm O.D x 20 mm I.D x 580 mm L).
It can be used under ultra-highly oxidizing and inert gas atmosphere up to 1100°C to process special compounds.
It is consumable part of OTF-1200X-HP-55 which is a compact HIP (hot isostatic pressure) furnace for researching new generation of materials at low cost.
Specification
Outside Diameter
50 mm
Inside Diameter
20 mm
Tube Length
580 mm
Chamber Length
•550 mm •Please click picture below to see detail of pressure vessel
Max. working temperature without load
1100 °C
Working Pressure & Temperature
Maximum pressure inside the tube (sf = 2)
Heating temperature
Max. 3045 PSI (21 Mpa)
800°C
Max. 1812 PSI (12.5 Mpa)
900°C
Max. 914 PSI (6.3 Mpa)
1000°C
Max. 609 PSI (4.2 Mpa)
1100°C
•The allowable pressure is calculated based on Barlow's formula. S = yield strength. Safety factory= 2 •Warning
○ The suitable tightening torque for turning the screws on this tube is 40 foot pound.
Click picture below for torque wrench detial. ○ Please set up pressure alarm point in digital pressure display before operation ○ Must install a pressure regulator on gas cylinder to increase pressure gradually. ○ Service life design for 2,000 hours at 800oC.
The high pressure vessel is consuamble part, please order replacement once found deformation ○
Installation
Attention
•Considered the toughnees of Ni-Based Alloy, you should tighten the screws in diagonal sequence and apply equal pressure. •Do not over tighten, always use the recommended torque screwdriver. •In order get longer tube service life, Please use quartz or alumia crucible to carry sample, instead loading sample directly inside tube, please click picture below to choose one crucible boat :
